Dell PowerConnect 5324 - Add SNMP Community

178 Configuring System Information
www.dell.com | support.dell.com
SNMP Management Station — A list of management station IP addresses.
Community String — Functions as a password and used to authenticate the selected management
station to the device.
Access Mode — Defines the access rights of the community. The possible field values are:
Read Only — The management access is restricted to read-only, for all MIBs except the
community table, for which there is no access.
Read Write — The management access is read-write, for all MIBs except the community
table, for which there is no access.
SNMP Admin — The management access is read-write for all MIBs, including the
community table.
Remove — Removes a community, when selected.
Defining a New Community
1 Open the SNMP Community page.
2 Click Add .
The
Add SNMP Community page opens:
Figure 6-71. Add SNMP Community
3
Select one of the following:
Management Station — Defines an SNMP community for a specific management station. (A
value of 0.0.0.0 specifies all management stations.)
All — Defines an SNMP community for all management stations.
4 Define the remaining fields.
5 Click Apply Changes .
The new community is saved, and the device is updated.