Installing the PowerConnect Device 35
Installing the PowerConnect Device
This section contains information about device unpacking, location, installation, and cable
connections.
Installation Precautions
CAUTION Before performing any of the following procedures, read and follow the safety instructions
located in the System Information Guide included in the Dell Documentation.
CAUTION Observe the following points before performing the procedures in this section:
• Ensure that the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable and/or falling over.
• Ensure that the power source circuits are properly grounded.
• Observe and follow the service markings. Do not service any device except as explained in the
system documentation. Opening or removing covers marked with a triangular symbol with a
lighting bolt may cause electrical shock. These components are to be serviced by trained
service technicians only.
• Ensure that the power cable, extension cable, and/or plug is not damaged.
• Ensure that the device is not exposed to water.
• Ensure that the device is not exposed to radiators and/or heat sources.
• Ensure that the cooling vents are not blocked.
• Do not push foreign objects into the device, as it may cause a fire or electric shock.
• Use the device only with approved equipment.
• Allow the device to cool before removing covers or touching internal equipment.
• Ensure that the device does not overload the power circuits, wiring, and over-current
protection. To determine the possibility of overloading the supply circuits, add together the
ampere ratings of all switches installed on the same circuit as the device. Compare this total
with the rating limit for the circuit.
• Do not install the device in an environment where the operating ambient temperature might
exceed 40ºC (122ºF).
• Ensure that the airflow around the front, sides, and back of the device is not restricted.
To Next Page
Loading...
Need help?
General
