Dell PowerConnect 5324 - DHCP IP Interface CLI Commands

126 Configuring System Information
www.dell.com | support.dell.com
2 Click Show All .
The
DHCP Client Table opens.
3 Select a DHCP client entry.
4 Select the Remove check box.
5 Click Apply Changes .
The selected entry is deleted, and the device is updated.
Defining DHCP IP Interfaces Using CLI Commands
The following table summarizes the equivalent CLI commands for defining DHCP clients.
The following is an example of the CLI command:
Table 6-28. DHCP IP Interface CLI Commands
CLI Command Description
ip address dhcp
[hostname host-name]
To acquire an IP address on an Ethernet interface from the
Dynamic Host Configuration Protocol (DHCP).
console> enable
console# config
console (config#) interface ethernet g1
console (config-if)# ip address dhcp 10.0.0.1 /8