Dell PowerConnect 5324 User Manual

34 Hardware Description
www.dell.com | support.dell.com
Power supply LEDs indicate the power supply status. For more information on LEDs, see "LED
Definitions".
AC Power Supply Unit
The AC power supply unit converts standard 220/110V AC 50/60 Hz to 5V DC at 5A, 12V DC at
3A. The unit automatically senses the available voltage rating (110 or 220V) and no setting is
required.
The AC power supply unit uses a standard AC220/110V connector. LED indicator is on the front
panel and indicates whether the AC unit is connected.
DC Power Supply Unit
An external DC power supply unit is used as a redundant power supply unit. Operation is possible
with power supplied from this unit only. RPS600 connector type is used. No configuration is
required. LED indicator is on the front panel and indicates whether DC unit is connected.
When the device is connected to a different power source, the probability of failure in the event of
a power outage decreases.
Reset Button
The reset button, located on the front panel, manually resets the device.
Ventilation System
The device uses a fan system for cooling. Fan operational status can be verified by observing the
LEDs that indicate if there is a faulty fan. For information, see "LED Definitions".

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2