Dell PowerConnect 5324 User Manual

342 Configuring Quality of Service
www.dell.com | support.dell.com
Interface — The specific port or LAG to configure:
Disable "Trust" Mode on Interface —
Set Default CoS For Incoming Traffic To — Sets the default CoS tag value untagged packets. The
CoS tag values are 0-7. The default value is 0.
Queue — The queue number.
Queue Mode — Indicates whether the queue is Strict Priority or WRR. This is defined in the
Queue Settings screen.
Weight (6-255) — Assigns WRR weights to queues. This field is enabled only for queues in WRR
queue mode.
% of WRR Bandwidth — The percentage translation of the weight defined in the Weight (6-255)
field.
Assigning QoS/CoS settings for an interface:
1 Open the Interface Cos/QoS Settings page.
2 Select an interface in the Interface field.
3 Define the fields.
4 Click Apply Changes .
The CoS settings are assigned to the interface.

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2