Dell PowerConnect 5324 - Page 204

204 Configuring Device Information
www.dell.com | support.dell.com
Port — The port number for which Advanced Port Based Authentication is enabled.
Multiple Hosts — Enables or disables a single host to authorize multiple hosts for system access.
This setting must be enabled in order to either disable the ingress-filter, or to use port-lock security
on the selected port.
Action on Single Host Violation — Defines the action to be applied to packets arriving in single-
host mode, from a host whose MAC address is not the client (supplicant) MAC address. The
Action on Single Host Violation field can be defined only if the Multiple Hosts field is defined as
Disable . The possible field values are:
Permit — Forwards the packets from an unknown source, however, the MAC address is not
learned.
Deny — Discards the packets from any unlearned source. This is the default value.
Shutdown — Discards the packet from any unlearned source and locks the port. Ports remain
locked until they are activated, or the device is reset.
Traps — Enables or disables sending traps to the host if a violation occurs.
Trap Frequency (1-1000000) (Sec) — Defines the time period by which traps are sent to the host.
The
Trap Frequency (1-1000000) field can be defined only if the Multiple Hosts field is defined as
Disable . The default is 10 seconds.
Status — The host status. The possible field values are:
Unauthorized — Clents (supplicants) have full port access.
Authorized — Clents (supplicants) have limited port access.
No single-host — Multiple Hosts is enabled.
Number of Violations — The number of packets that arrived on the interface in single-host mode,
from a host whose MAC address is not the client (supplicant) MAC address.
Displaying the Multiple Hosts Table
1 Open the Multiple Hosts page.
2 Click Show All .
The
Multiple Hosts Table opens: