224 Configuring Device Information
www.dell.com | support.dell.com
The following is an example of the CLI commands:
flowcontrol {auto | on | off | rx |
tx}
Configures the Flow Control on a given
interface.
show interfaces configuration
[ethernet interface| port-channel
port-channel-number]
Displays the configuration for all configured
interfaces.
show interfaces status [ethernet
interface |port-channel port-
channel-number]
Displays the status for all configured
interfaces.
show interfaces description
[ethernet interface |port-channel
port-channel-number]
Displays the description for all configured
interfaces.
show interfaces port-channel
[port-channel-number]
Displays Port-channel information (which
ports are members of that port-channel, and
whether they are currently active or not).
Table 7-54. LAG Configuration CLI Commands
CLI Command Description
console(config-if)# channel-group 1 mode on
console(config-if)# exit
console(config)# interface range e g21-24
console(config-if)# channel-group 1 mode on
console(config-if)# ex
console(config)# interface ethernet g5
console(config-if)# channel-group 2 mode on
console(config-if)# exit
console(config)# exit
console# show interfaces port-channel
Channel Ports
--------- ---------
ch1 Inactive: g(21-24)
ch2 Active: g5
To Next Page
Loading...
