Configuring Device Information 281
Bridge Multicast
is enabled on the device.
Enabling IGMP Snooping on the Device
1
Open the
Multicast Global Parameters
page.
2
Select
Enable
in the
IGMP Snooping Status
field.
3
Click
Apply Changes
.
IGMP Snooping is enabled on the device.
Enabling Multicast Forwarding and IGMP Snooping Using CLI Commands
The following table summarizes the equivalent CLI commands for enabling Multicast forwarding
and IGMP Snooping as displayed on the
Multicast Global Parameters
page.
The following is an example of the CLI commands:
Table 7-74. Multicast Forwarding and Snooping CLI Commands
CLI Command Description
bridge multicast filtering Enables filtering of Multicast addresses.
ip igmp snooping Enables Internet Group Membership
Protocol (IGMP) snooping.
Console (config)# bridge multicast filtering
Console (config)# ip igmp snooping
To Next Page
Loading...
