Dell PowerConnect 5324 User Manual

Viewing Statistics 297
Refresh Rate — The amount of time that passes before the interface statistics are refreshed.
Interface — The interface number.
Interface Status — Status of the interface.
% Interface Utilization — Network interface utilization percentage based on the duplex mode of
the interface. The range of this reading is from 0 to 200%. The maximum reading of 200% for a full
duplex connection indicates that 100% of bandwidth of incoming and outgoing connections is
used by the traffic travelling through the interface. The maximum reading for a half duplex
connection is 100%.
% Unicast Received — Percentage of Unicast packets received on the interface.
% Non Unicast Packets Received — Percentage of non-Unicast packets received on the interface.
% Error Packets Received — Number packets with errors received on the interface.
Global System LAG — Current LAG/trunk performance.

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2