300 Viewing Statistics
www.dell.com | support.dell.com
Interface
— Specifies whether statistics are displayed for a port or LAG.
Refresh Rate
— Amount of time that passes before the interface statistics are refreshed.
Receive Statistics
Total Bytes (Octets)
— of octets received on the selected interface.
Unicast Packets
— of Unicast packets received on the selected interface.
Multicast Packets
— of Multicast packets received on the selected interface.
Broadcast Packets
— of Broadcast packets received on the selected interface.
Packets with Errors
— of error from the selected interface.
Transmit Statistics
Total Bytes (Octets)
— of octets transmitted on the selected interface.
Unicast Packets
— of Unicast packets transmitted on the selected interface.
Multicast Packets
— of Multicast packets transmitted on the selected interface.
Broadcast Packets
— of Broadcast packets transmitted on the selected interface.
Packets with Errors
— of error transmitted from the selected interface.
Displaying Interface Statistics
1
Open the
Interface Statistics
page.
2
Select an interface in the
Interface
field.
The interface statistics are displayed.
Resetting Interface Statistics Counters
1
Open the
Interface Statistics
page.
2
Click
Reset All Counters
.
The interface statistics counters are reset.
Viewing Interface Statistics Using the CLI Commands
The following table summarizes the equivalent CLI commands for viewing interface statistics.
Table 8-80. Interface Statistics CLI Commands
CLI Command Description
show interfaces counters [ethernet
interface | port-channel port-channel-
number]
Displays traffic seen by the physical
interface.
To Next Page
Loading...
