Bravo-Brava
Electrical equipment
Radio equipment
55.
Dolby B Function
Press switch (17) to activate / deactivate the
Dolby B function (device for limiting the
noise produced under licence by the "Dolby
Laboratories Licensing Corporation") (*).
When the Dolby function is activated, the
LED under the switch comes on and the ap-
propriate symbol (illustrated in the diagram,
bottom left) appears on the display.
(*) Dolby and the symbol (two Ds) are reg-
istered trade marks of the above compa-
ny.
Ejecting the cassette
- Press switch (22) briefly to open the cas-
sette housing protective flap;
- press switch (22) briefly a second time to
eject the cassette.
NOTE
The same
result is achieved by keep-
ing the switch (22) pressed until the
cassette is ejected.
- After the tape is ejected the word "TAPE"
appears on the display and the radio starts
to work, tuning in to the last station
lis-
tened to.
NOTE The cassette cannot be ejected with
the radio off.
Never expose cassettes to heat or to
direct sunlight, but a/ways store
them properly after use.
It is advisable to use good quality
cassettes, no longer than C-90 in
order to a/ways ensure optimum re-
production.
Impurities on the head caused by
tapes can result, in time, in de-
creased high tones during repro-
duction. It is therefore advisable to
clean the heads periodically using a
special non abrasive type head
cleaning cassette.
Copyright by Fiat Auto
50/15
To Next Page
Loading...
