Bravo-Brava
Bodywork
Seats
70.
REMOVING-REFITTING SEAT RAISE
DEVICE
The seat need not be removed from
the car.
1.
Position the seat fully forward and fully
raised.
Unscrew screws retaining outer
trim A. Turn trim B upward.
P4A024M09
4.
Remove panel C covering seat raise lever
fastener. Take care not to break the tabs.
Remove the lower part by hand (box 1)
and then use a screwdriver to prise up the
upper tab (box 2) and remove the panel.
Remove lever D and drill off the head of
rivets E.
Unscrew bolts F retaining the seat raise
device and then remove.
NOTE Reverse removal instructions to refit.
Tighten retaining bolts to a torque
of 1.2 daNm.
P4A024M11 P4A024M12
Copyright Fiat Auto
Vj98^
t||dat<|
24/1
To Next Page
Loading...
