Bravo-Brava
Electrical equipment
Alarm
The programming of a transmitter should be carried out with the:
1) the emergency key is in the ON position;
2) the anti-theft device is switched off via the remote control;
3) the igntion key is in the OFF position or has been removed.
55.
LED off
LED flashing
LED on constantly
Start of simplified programming (first remote control)
The simplified programming can only be used when the memory has not yet been closed (see chapter on
"Protected programming"). The system "recognizes" the code for an unlimited number of remote
con-
trols,
but only the last eight remote controls remain programmed (when the 9th remote control is en-
tered the first one is expelled from the memory).
1) Press the programming button on the re-
ceiver; the LED for the receiver will start to
FLASH indicating "awaiting to receive a
code";
If the LED remains off when the
button is pressed, this means
that:
a) the alarm is ON. If this is the
case, it can only be switched off
using the UNIVERSAL REMOTE
CONTROL;
b) the receiver is faulty or there is
no supply.
Copyright by Fiat Auto
l
"-
96
"
Cancels anct
re
P
|aCM
1
37
To Next Page
Loading...
