Fiat Brava - Checking that the Memory Is Closed

Electrical equipment
Alarm
Bravo-Brava
55.
CHECKING THAT THE MEMORY IS CLOSED
If a remote control is programmed with the memory closed, as illustrated below, at the end of the opera-
tions the LED will remain off indicating that the operation has not been accepted.
For example
1. Press the programming button in the re-
ceiver. The LED for the receiver will start
to flash indicating "waiting to receive a
code".
^T^^S
^MJ^^i
/
^
===
\ t
[Td
-v^Ocm
^^ I
The operator, still keeping the receiver
button pressed, should press and release
the button for one of the remote controls
which come with the vehicle (keeping it
about 40 cm away).
After having transmitted the new code the
LED in the courtesy light will stop flashing
indicating the failure of the operation. If
this is the case, in order to enter the code
for a new remote control it is necessary to
use the code programming with manual
access.
144 III-96 - Cancels and replaces
Prjnt no 506670/06