Bravo-Brava Electrical equipment
Alarm
55.
0 impulses
When a "zero" appears in the password,
the button in the receiver should not be
pressed, but you should wait for
a
new re-
quest to enter the figure indicated by the
flashing.
8. After about 2 seconds the LED will emit
another flash to request the input of the
last figure (the 3).
3 impulses
9. Immediately press the button for the re-
ceiver as many times as indicated by the
last digit of the password (for example: 3
times);
it should be noted that for each impulse
the LED will come on briefly to give a vi-
sual confirmation.
After having entered the four figures of the
password,
the LED in the receiver may be-
have in the following way:
a) come on flashing (for 10 sees); this
indi-
cates that the Password has been entered
correctly and belongs to one of the codes
for the remote controls programmed;
b) come on constantly for several seconds
(10 sees) to indicate that the password
has not been correctly entered or that it
does not correspond to any of the codes
for the remote controls programmed. If
this is the case, after the LED goes out, the
correct password should be reintroduced
starting from point 1;
- when the password has been correctly
entered,
the memory will be "closed".
P4A25AL03
Copyright by Fiat Auto
VII-95 - Cinci Is cm\ it-places
143
To Next Page
Loading...
