Electrical equipment
Alarm
55.
SWITCHING ON ALARM EXCLUSION (To be carried out compulsorily each time it is switched on)
It is possible to exclude the operation of the alarm when switching on the alarm by pressing the remote
control switch for 4 seconds. Straight after the audible/visual signals that it has been switched on (see
previous page) to indicate that it has been excluded 5 audible signals (beeps) follow in quick succes-
sion.
SIGNALLING REMOTE CONTROL BATTERIES DISCHARGED
The fact that the remote control batteries are discharged is signalled by a single 200 ms (millisecond)
flash of the remote control LED each time the switch is pressed.
When this signal occurs it is necessary to change the remote control batteries as soon as possible
DISTANCE BETWEEN TRANSMITTER AND RECEIVER DURING PROGRAMMING
The distance of the remote control from the receiver in the courtesy light is about 40 cm.
Bravo-Brava
134/2
II
'-
96
-
u
P
date
Print no. 506.670/06
To Next Page
Loading...
