Bodywork
Replacing body panels
Bravo
70.
11.
Damper panels. Fit the damping panels to the inside of the wing.
12.
Foam. Apply the foam through the openings shown.
13.
Preparing any joins to be shaded and/or preparing the elements adjacent to the shading, wet sand-
ing with P1200 grade abrasive paper or with abrasive polish.
14.
Protection (after checking the tint).
Use industrial paper which does not release volatile impurities.
15.
Blowing and preparing for painting.
Wash with anti-silicon diluent and dry, lastly clean with a chemical wad.
16.
Painting. Follow the technical specifications and the instructions for applying enamels, recom-
mended in the technical charts from the manufacturers of the product used.
17.
After painting, spray the product on the parts which are not accessible, especially the continuous
spot welds.
80
Print no. 506.670/01
To Next Page
Loading...
