Bodywork
Replacing body panels
Bravo-Brava
70.
Removing off cuts and preparing edges of bodyshell
1.
Remove the weld points along the entire perimeter of the edge of the bodyshell, using a special cut-
ter- vtl.
2.
Remove the metal off cuts using pliers.
3. Straighten the edges with a hammer and dolly block.
4.
Remove the weld residues using a disc grinder.
5. Remove the centre rib, undoing the fixing bolts.
6. Apply the IVI Epox epoxide type primer or an electro-weldable galvanized paint or an equivalent
product, to the areas previously ground.
P4A090M01
Preparing the spare part
1.
Apply a base coat using a spray gun.
2.
Remove the anti-corrosion treatment from the entire perimeter of the inside and the outside of the re-
placement part using a disc grinder.
3. Use electro-galvanizing paint on the edges in contact with the bodyshell.
HL
6
' ^^^a»
J
h
90 Print no. 506.670/01
To Next Page
Loading...
