GE Voluson 730Pro - M Operation

M Mode
6.2 M Operation
The M operation consists of : Cursor Position (chapter 6.2.1)
Activation of M Mode
(chapter 6.2.2)
Sweep Speed
(chapter 6.2.3)
Invert
(chapter 6.2.4)
Frequency
(chapter 6.2.5)
TGC Slide Controls
(chapter 6.2.6)
M Mode Depth
(chapter 6.2.7)
M Gain Control
(chapter 6.2.8)
M Cineloop
(chapter 6.2.9)
6.2.1 Cursor Position
After pressing the [M] control adjust the M-cursor using the trackball in the 2D single
image.
6.2.2 Activation of M Mode
Press the right or left trackball key and 2D mode and M mode trace are active.
The screen is divided asymmetrically. In the smaller image above the 2D image
appears. In the image below the M mode trace starts running.
Three display formats are possible, review: Format
(chapter 6.3.1)
The [Freeze] key stops the 2D image and M mode trace.
Note:
By pressing the [Freeze] key again, the M-cursor appears on the active 2D image.
Voluson
®
730Pro - Basic User Manual
6-4 105831 Rev. 0