Volume Mode
11.2.6.2 A,B,C - Sectional Plane Mode
This display mode is active if you press the [Quad] screen format key.
The 3 sectional planes A, B and C are standing normal on each other.
The intersecting lines of the planes are the axes of the relative coordinate system and they
are displayed in colors in the different images planes.
This display mode is basic for the other display modes.
11.2.6.3 Reference Image Mode
Pressing the [Single] screen format key will magnify x2 and display the reference image
A, B or C. For the REF image plane selection the same rules as for sectional planes
mode apply. The graphic display of the orientation help is not possible.
11.2.6.4 Niche Display Mode
Principle:
Parts of the orthogonal sections A, B and C are compiled to a 3D section aspect. The name “Niche”
has been chosen because the aspect shows a quasi spatial cut into the reference image.
Operation:
4. Select the [Niche] display format item.
The Niche display mode appears on the monitor.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 11-25
To Next Page
Loading...
