TD Mode
10.3.10 Smoothing
A temporal average is determined from several color images, so that different filter periods can be
selected for rising velocity and falling velocity.
Rotate the [Smooth] digipots and select the rise and the fall filter.
RISE: Filtering of the rise velocity leads to noise suppression.
Avoid quick movements of the probe, because the motion is "built up" slowly.
When displaying pulses the Rise-Filter must be set low.
FALL: This filter leads to prolongation of the displayed motion.
To be used with quick pulses (short "color flashes") to prolongate them for better evaluation
on the monitor.
Remarks:
* Changes are only possible in write mode.
Voluson
®
730Pro - Basic User Manual
10-12 105831 Rev. 0
To Next Page
Loading...
