Starting the System
4.7.4 Pictogram
For the documentation of the scan position on the patient, a selection of graphic body symbols
(bodymark) is available. The scan position is indicated by a short bright line. This line can be
positioned freely on the bodymark symbol.
Pressing the [Bodymark] key causes the menu area to change to the bodymark menu.
The previously used bodymark is shown on the screen.
Operation
:
1. Switch on the pictogram function (hard key).
The last selected pictogram appears in the last selected place of
the annotation area.
2. To change the displayed pictogram, select the
[New Symbol] item and choose the desired bodymark with the
trackball.
3. Position the scan plane identification line with the trackball.
4. Adjust the direction of the mark by turning the Rotate-digipot.
5. Press the left or right trackball key [Set] to fix the scan plane identification line and return to the
last active menu with the displayed bodymark.
6. Press the upper trackball key to change from position of the scan plane identification line to
position of the pictogram symbol in the annotation area.
Note:
• The scan plane identification is shown in the write mode and the read mode.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 4-21
To Next Page
Loading...
