Volume Mode
11.4.3.2 Start/Stop the Calculated Sequence
Toggle function: [Start / Stop]
Press the right or left trackball key to initialize the 3D cine sequence.
On screen the cine sequence begins rotating ( if not rotating already).
Loop Mode Direction
If several 3D images have been calculated, they can automatically be displayed in a sequence.
Images in Transparent mode will only render the 3D effect in this manner.
Scan in both directions through the image block:
First image...last image, last image...first image, etc.
Scan in one direction through the image block:
First image...last image, first image...last image, etc.
Select the speed of rotation
The speed of sequencing through the number of images can be varied between:
6%, 12%, 25%, 50%, 100%, 200%, and 400%.
Select the aspect ratio
The 3D image magnification can be varied by its aspect ratio.
Selection of single images:
After pressing the right or left trackball key [Stop] move the trackball horizontally
and you can select each single image step by step.
Press [Start], right or left trackball key to resume automatic rotation.
The displayed number indicates: ( 2 / 10 ): image number of the sequence.
Mix the calculate modes:
Switching this flip control adjusts the mix ratio between the two calculated modes.
Edit calculated Cine sequence
By selecting this item the “3D CinePre” menu appears again.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 11-47
To Next Page
Loading...
