Volume Mode
3. Select the Rotation Angle
Select the rotation angle you want.
Alternatively use the [Start] and [End] digipot controls to select the
rotation angle desired.
4. Select the Step Angle
The step raster defines the amount of rotation between adjoining 3D
images.
5. Select Calculate
Alternative press either the right or left trackball key [Calculate].
Image after image of the sequence is calculated and stored in the cine memory.
After the calculating is done the rotating cine sequence is displayed on the screen.
To break the Cine calculation:
Activation of the right or left trackball key [Break] stops the actual calculation. If at
this moment no image calculation has been performed, an automatic return to the 3D
ROI menu will happen.
If, however, at least 1 image calculation is finished (status line “Calculating image” shows a number
> 1), the calculation quit, the calculated cine sequence (until to the interruption) is displayed and the
cine menu appears.
Possible operation of a displayed cine sequence
review: Start/Stop the calculated Sequence
(chapter 11.4.3.2)
Voluson
®
730Pro - Basic User Manual
11-46 105831 Rev. 0
To Next Page
Loading...
