Sonoview
15.3.3 To Magnify Images
This enables magnification of a region of interest of an image.
When the [Magnifier] tool is active, the mouse cursor appears as a magnifier icon.
Move the cursor (icon) to the image and press the right trackball key and hold the key to activate the
magnifier.
Move the Magnifier (using the trackball) over the image to view the region of interest.
To cancel the magnification, release the key. To cancel the Magnifier, select the magnifier icon.
15.3.4 Report
Additional data and comments can be entered into the report of the currently selected exams.
After completing the report, click the [OK] button to save the content, otherwise click the [Cancel]
button.
15.3.5 To Measure Distance
This provides the function for measuring the distance between two points within the image.
Note:
The Full Screen View must be selected, otherwise this function does not work.
Select the [Distance] icon and move the cursor to the image. The cursor changes to a “+”.
Place the cursor at the start point to begin the measurement, and then press the right or left trackball
key [Set]. After placing the cursor to the end point that you want to measure, press the right trackball
key [Set], and the distance of the two points is displayed.
Several measurements can be made in the same manner.
Click the [Distance] icon again to exit the measurement function.
Select the [Clear Measurements] button on the lower part of the
image to delete the displayed measurements.
Voluson
®
730Expert - Basic User Manual
15-14 105850 Rev. 0
To Next Page
Loading...
