Printing / Recording / Saving / Sending
16.1.1 DICOM Print
Condition:
The DICOM printer is connected to the remote control socket at the rear panel
and the [Print A] or [Print B] key can be assigned to a DICOM printer.
Operation:
1. Press the Printer Trigger key which is assigned to the DICOM Printer on the control panel to store
an image or report page.
The DICOM Configuration window appears.
2. Mark the line with the desired DICOM Address.
Note:
Only lines with Service “PRINT” and only one address can be selected.
For further details review System Setup: To specify a DICOM Address
(chapter 17.3.8.1)
The “DICOM print” menu will be displayed in the menu area.
Printer Info:
• Alias : V730 (depends on Printer Setup)
• Format: 2 x 3 (depends on Printer Setup)
• Pages: 1
• Images: 3 / 6 3 images are currently stored
6 are possible at selected Print Format
To change the Printer Format
review: To specify a DICOM Address
(chapter 17.3.8.1)
3. Select the [Store] item.
4. Repeat 1. and 3. to store as many images as desired.
Note:
Press the [Print A] or [Print B] key which is assigned to the DICOM Printer twice to store the
selected image or report page. In this case the “DICOM print” menu will not be displayed !
4. If desired, delete either all or the last stored image.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 16-3
To Next Page
Loading...
