GE Voluson 730Pro - Distance Measurements

Basic Measurements
13.2 Distance Measurements
The item “Distance” supports 2 types of measurements.
• 2D Distance Measurement
(chapter 13.2.1)
• M Distance Measurement
(chapter 13.2.2)
13.2.1 2D Distance Measurement
To measure the distance between two points on the image:
1. Select the [Distance] item.
2. Use the trackball to move the cursor to the start point of the measurement and press the right or
left trackball key [Set] to fix the marker. A second cursor appears.
3. Use the trackball again to move the second cursor to the second point of the measurement and
press the right or left trackball key again to fix the marker.
To re-adjust the start point, press the upper trackball key [Change] before completing the
measurement. This alternates the control from one cursor to the other.
Remarks:
• The result of the distance calculation will be displayed on the monitor.
• A new cursor will appear. If necessary continue to calculate another distance in the same manner.
Voluson
®
730Pro - Basic User Manual
13-4 105831 Rev. 0