Basic Measurements
13.6 Diverse Measurements
• Hip Joint Measurement
(chapter 13.6.1)
13.6.1 Hip Joint Measurement
Necessary measurements: The order of entering the lines 1 to 3 must be followed.
Sketch: a-b (line 1) c-d (line 2) e-f (line 3)
To measure the Hip Joint angle in 2D mode:
1. Select the [Hip Joint] item. A cursor appears.
2. Enter line 1 (a-b), 2 (c-d) and 3 (e-f) consecutively.
Use the trackball to move the cursor to the start point of the measurement and press the right or
left trackball key to fix the marker. A second cursor appears.
To re-adjust the start point, press the upper trackball key [Change] (prior to completing each
distance measurement). It alternates the control from one cursor to the other.
3. Enter the second line in the same way.
4. Use the trackball again to move the third cursor to the third point of the measurement, and press the
right or left trackball key to fix the marker.
5. After storing the 3rd line the evaluation appears on the screen.
α = .. °
ß = .. °
TYPE:
Voluson
®
730Pro - Basic User Manual
13-14 105831 Rev. 0
To Next Page
Loading...
