Biopsy Setup
19. Biopsy Setup
Introduction
Programming of Biopsy lines is done in the Biopsy Setup.
Note:
Only one Biopsy line for each probe is possible.
Generally operations are done with the trackball and the Rotation control.
The trackball positions the Biopsy line.
Control for rotation of the Biopsy line.
To invoke the Biopsy Setup:
Condition: To invoke the Biopsy Setup, 2D mode must be active.
Press the [Utilities] key on the control panel.
The monitor changes to the Utilities menu.
Select the [Biopsy] item to activate the Biopsy Line programming.
review: To program a Biopsy Line (chapter 19.1)
Voluson
®
730Pro - Basic User Manual
19-2 105831 Rev. 0
To Next Page
Loading...
