GE Voluson 730Pro - General Measurement Setup

Measurement Setup
18.3.1 General Measurement Setup
The General page on the monitor:
2D Circumference and Area Method:
Only one method is selectable.
Select either if the circumference and area calculations in OB, GYN and Vascular should be
performed using an Ellipse or using Trace.
Doppler Manual Trace Mode:
Only one method is selectable.
Select either if the Spectral Doppler envelope curve should be performed with a continuous trace line
or by setting points.
Report Calculation Mode:
Only one method is selectable.
Select either if the average of same measurements, or the last measured result should be used for
further calculations. (displayed in the report page)
Store Measurements:
Only one method is selectable.
Select either if only the [Set] keys (right or left trackball key), or also the [Freeze] key should be used
for confirming the last measuring mark of the currently performed measurement.
Show Caliper Information Text:
Select if the displayed Measurements will be shown with or without Caliper Information Text.
Voluson
®
730Pro - Basic User Manual
18-4 105831 Rev. 0