GE Voluson 730Pro - The Render Box

Volume Mode
11.1.5 The Render Box
To obtain a good 3D picture, the following three points are very important (similar to a photography):
• the direction of view
• the area/size of view
• free sight to the object (surface mode)
This has to be adjusted with the render box. The render box determines the size of the volume to be
rendered. Therefore, objects which are not inside the box will not be included in the render process
and cut out (important for the surface mode to cut off objects, which interfere with a free line of sight).
The positioning of the box inside the scanned volume is done with help of the orthogonal sectional
planes A, B and C, each of which cut through the box in the middle.
Review the following diagram to understand how the render box determines the direction of view.
Six different render box directions are possible.
2
4
6
1
3
5
To select the view direction review: Render View Direction
(chapter 11.3.1)
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 11-9