Measurement Setup
18.3.2 Obstetric Measurement Setup
Select [OB] with the mouse pointer and press [Set] (right trackball key).
The Obstetric Setup “General” page appears on the monitor.
This page is for selection of general (standard measurement combinations), Fetal Biometry
measurement combinations or User defined measurement combinations.
Choose the desired measurement combination
from the pop-up menu.
Remarks:
• If “General” is selected press the [Calc] key on the control panel and [Fetal Biometry] , [Fetal
Long Bones] and [Fetal Cranium] measurement groups are available.
• If “Fetal Biometry” is selected press the [Calc] key on the control panel and the measurement
group [Fetal Biometry] is available only.
• If an “User defined combination” is selected press the [Calc] key on the control panel the
measurement group with the chosen variables (max. 18) is available.
To program a User combination see: To Define a New User
(chapter 18.3.2.1)
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 18-5
To Next Page
Loading...
