GE Voluson 730Pro - Threshold Control in Color Render Mode; Transparency in Color Render Mode

Volume Mode
11.4.2.2.1 Threshold Control in Color Render Mode
Threshold Low (Reject):
Normally this threshold must always be adjusted for a good appearance
of the 3D surface image.
By changing the [PD Low], all echoes below the threshold level are enhanced in pink color for a
certain interval. All the color values below this level (pink
in the B Scan) will be disregarded for the
calculation of the surface.
11.4.2.2.2 Transparency in Color Render Mode
small number = low transparency
A higher number makes the color scale information more transparent.
If a 3D+CFM or a 3D+PD image is acquired, the controls for the
[Balance] and the [Power Threshold] are displayed after selecting the
[Sub Menu] item.
review: Balance
(chapter 11.3.5)
Power Threshold
(chapter 11.3.6)
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 11-43