GE Voluson 730Pro - Sphere - Computer-Assisted Contour Mode

Volume Mode
11.6.1.1 Sphere – Computer-assisted Contour Mode
This function is only useful if you want to outline the surface of a sphere. Using this function a sphere
round the main contour axis is generated within the two green arrows. The number of generated
contours depends on the selected rotation step.
Operation:
Select the [Sphere] contour mode item.
The contour of the 3D data set is calculated automatically.
The VOCAL-Edit Contour menu is displayed in the menu area on the monitor.
If necessary, edit the contour
review: VOCAL - Edit Contour
(chapter 11.6.2).
Select the [Accept ROI] item to accept the computer-assisted contour.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 11-69