GE Voluson 730Pro - Dynamic; Exit the PW Submenu; PW + 2 D + Color Information (Triplex Mode)

Spectral Doppler Mode
7.1.3.4 Dynamic
Dynamic refers to the compression of grayscale information into a suitable range for the display.
Dynamic allows you to enhance a part of interest of the grayscale to make it easier to display
pathology.
It adjusts the displayed cutoff of the Doppler analysis waveform.
Turn clockwise to decrease the brightness (more gray shades) ; turn counterclockwise to increase the
brightness (fewer gray shades).
max. range: 40
min. range: 10
step size: 2
Remarks:
*
The appearance of the gray values depends also on the selected Gray Map.
To select a PW gray map review: Gray Chroma Map
(chapter 12.1)
*
Changing the PW Dynamic is only possible in write mode!
7.1.3.5 Exit the PW Submenu
Press the [Exit] key on the control panel to exit the PW Submenu.
•
•
7.1.4 PW + 2D + Color Information (Triplex Mode)
Triplex mode is the simultaneous real time display of 2D mode, Spectral Doppler and Color Doppler.
There are two possibilities to combine Pulsed Wave Doppler (PW) with Color Information:
PW + 2D mode + Color Doppler mode (CFM)
PW + 2D mode + Power Doppler mode (PD)
With the [Change Menu] key on the control panel it is possible to switch between PW
menu, CFM and PD menu and the appendant Submenus to readjust the settings.
Remark:
Changing the mode menu is only possible in write mode.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 7-13