CFM Mode
8.2.7 Invert
This function inverts the color display in relation to the direction of the flow.
The color of the color wedge inverts around the baseline.
key unlit Normal: Flow to the transducer RED.
Flow away from the transducer BLUE.
key lit Inverted: Flow to the transducer BLUE.
Flow away from the transducer RED.
8.2.8 2D + 2D/C
The “2D+2D/C” function changes the single image display to two simultaneous half frames.
The left frame shows only the 2D mode image.
The right frame shows the 2D mode image also with color information.
Switch on/off this mode by selecting the [2D+2D/C] item.
Remarks:
* Changes are only possible in write mode.
8.2.9 Threshold
After [Freeze] you can adjust the Color Threshold.
This function eliminates small color noise of motion artifact signals in the Color image.
A small number cuts off fewer signals than a higher number.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 8-7
To Next Page
Loading...
