Printing / Recording / Saving / Sending
16.3.7 Sending Images to a DICOM Server
After DICOM Configuration and Selection of the Save destination “DICOM Server” in the System
Setup, 2D Images, 3D Volume Images and Image Sequences (2D Cine, 3D Rot.Cine and 4D Cine) can
be sent to the specified DICOM address.
Patient information must be entered first via the Patient Information menu.
review: Standard Input
(chapter 4.6.2)
Operation:
1. Press either the [2D saving] or the [3D/4D saving] key to invoke the
corresponding Save menu.
2. If necessary select the destination (DICOM Address) review: DICOM Configuration
(16.3.7.1)
3. Select one of the available DICOM Send Modes by selecting the respective item.
2D Image: The 2D image(s) on the screen will be sent.
2D Cine: The selected sequence of 2D images will be sent.
3D Volume: 2D images with 3D dataset (in polar or cartesian format)
3D Rot. Cine (Sequence of a rotating 3D image) or a
4D Cine (Sequence of 3D images ) will be sent.
4. If wanted, enter additional Comments
review: Save with Comment
(chapter 16.3.6)
5. Select this item to send to the selected destination.
6. Press the right or left trackball key to save the selected item to the external
DICOM server.
Note:
Press these keys twice to store the displayed Image or Volume to the
selected Save Destination (Sonoview or DICOM Server).
To select the save destination review System Setup: Peripherals
(chapter 17.3.3)
Voluson
®
730Pro - Basic User Manual
16-14 105831 Rev. 0
To Next Page
Loading...
