Volume Mode
11.4.2.2 Color Render Mode
In Color Rendering color information of Color or Power-Doppler signal can be used for the 3D
display.
1. Activate Color Rendering Mode (if not active).
2. Select desired render algorithm.
Note: Always select 2 modes!
-
-
-
Surface Mode: Surface display of color information of blood flows.
Light Mode: A surface will be displayed in "light" mode.
Light: structures close to viewer are displayed bright, structures distant to
the viewer are darker.
Maximum-Mode: The maximum color values of the ROI are displayed.
Application:
Representation of all vessels in the ROI. 3D impression can be observed
with rotation of the display.
X-Ray Mode: All color values in the ROI are used for the calculation and are averaged -
(impression will be an X-Ray image).
The software module allows selection from 2 modes which are simultaneously calculated.
Selection itself is liberal, except with the Light mode which combines only with Surface display.
The following Rendering combinations are possible:
Acquisition in Power mode
Surface + Light
Surface + Maximum
Surface + X-Ray
In case Surface mode is selected, it will normally be necessary to adjust the low and the high threshold
for the border recognition of the surface.
The threshold values do not apply for the Transparent modes!
Voluson
®
730Pro - Basic User Manual
11-42 105831 Rev. 0
To Next Page
Loading...
