Technical Data / Information
23.11 Volume Scan Module
Vol. scan size: max. 64 MB
The required memory space depends on scan parameters (VOL-box
size and quality (low , mid1 , mid2 , high1 , high2).
typ.: 1-5 MB
Lines/2D-image: max. 1024 (typ. 80 to 350)
2D-images/volume: max. 1024 (typ. 50 to 250)
VOL-Frames/sec.: max. 16 (typ: 3-5)
The frame rate depends on scan parameters (VOL-Box size, quality and probe.
Display of sectional plane images:
synchronous with control setting, arbitrary movement in volume,
monitored position in volume.
Rotation: 360°, 0.5° increments (X-, Y- and Z-axis)
Magnification: adjustable from 0.25 to a factor of 4.00
3D-Rendering: Calculation and display of rendered gray scale images:
surface mode, maximum mode, minimum mode;
calculation time depending on rendering box size
Calculation and display of rendered color-images:
3D PD Mode: surface mode, max. intensity mode
3D CFM mode: display of flow direction ,surface mode, maximum
Display Modes: 3-section Mode
A triplet of 3 sectional planes normal to each other is displayed.
Full size image
Display of 1 single full-screen image.
Niche image
Display of the sectional plane triplets within the (graphics) cube.
4 section Mode
Display of sectional images + calculated 3D images
Display graphics: Color display of the center of rotation and the axes.
Voluson
®
730Pro - Operation Manual
23-8 105831 Rev. 0
To Next Page
Loading...
