Volume Mode
11.4.4.1 MagiCut Operation
1. Select the [MagiCut] item.
The “MagiCut” menu appears in the menu area.
Remark:
• The system switches to “ROI 3D Quad mode”
(if not active) for editing the render box.
• 3D image display is activated if not active.
2. Use the digipots to rotate the rendered 3D image to a
position where the 3D artifacts or undesired
information can be cut.
Note:
For faster rotating press on the digipots control (switch function: slow rotation , fast rotation).
3. Select the “Cut Mode” and set the region of interest to be cut
• Trace Mode inside, outside
Trace Inside:
The image within the contour will be discarded.
Trace Outside:
The image outside of the contour will be discarded.
Position the first point, enter it with right or left trackball key [Set] and move the cross along the
desired trace. The red lines marking the trace set automatically.
Press the right or left trackball key [Set] again.
The region inside/outside the trace will be cut from the 3D rendered image.
If a contour is left open, the program will automatically close the contour with a line directly from the
end point to the start point.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 11-49
To Next Page
Loading...
