System Setup
17.3.2.2 To Save a 3D/4D Program
This tool saves current 3D/4D settings of the system under a 3D/4D program button.
1. Select the [3D/4D programs] button.
Note:
Only available after a 3D acquisition.
The 3D/4D Settings select menu appears on the monitor.
2. Select a program button and press [Set] (labeling area and cursor are displayed inside).
3. Enter a new program label using keyboard or
overwrite the existing label or
don’t change an existing program label, if the same term is desired.
4. Select [Save&Exit]. The program parameters are saved in the database.
Exit: Back to the last active menu.
Delete: To delete stored Settings.
Save: To save Settings with the active Settings select menu.
Return: Back to the User Setting main menu.
Default: A change of the default setting is protected by a password.
The label “Default” cannot be changed by the User.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 17-9
To Next Page
Loading...
