2D Mode
5.16 Cine Mode
While scanning a certain number of frames (2D images of the last examination sequence) will be
stored in the cine memory upon [Freeze]. The sequence can be reviewed image by image.
Move the trackball horizontally to display the 2D images of the stored sequence,
one by one.
They last stored sequence consists of images from the last scan procedure and
will be stored until the next scan procedure by [Freeze].
Display: "Cine: xxx" in the monitor’s status area.
Cine-Split-Function for Dual- and Quad format review: Cine-Split Function
(chapter 5.16.1)
2D Auto Cine for Single-, Dual- and Quad format review: 2D Auto Cine
(chapter 5.16.2)
Remarks
:
• The number of stored images depends on the number of scan lines, scan depth and
magnification. In read mode the length of the sequence is indicated on the monitor.
Display: Cine xxx
* Starting the Cine mode erases measuring marks and measuring displays.
* The Cine Function (operation and storage) is identical in 2D mode and CFM mode.
5.16.1 Cine-Split Function
After Freeze of a sequence in Multi-format 2D mode, two or four different images of the sequence can
be displayed simultaneously in Dual or Quad display mode.
1. Move the trackball horizontally to display the 2D images of the stored sequence.
2. Using the [Format] keys you can change to the next (part of)
frozen 2D image sequence to play back the cine memory.
Remarks
:
* In Dual image mode 2D cine each image takes half of the memory as in Single mode.
* In Quad image mode 2D cine each image takes only one quarter of the memory.
* The Cine-Split function (multiple format) is also possible with 2D Auto Cine
(chapter 5.16.2)
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 5-15
To Next Page
Loading...
