Starting the System
Probe selection menu on the screen:
Probe window:
Shows all connected probes,
the active one is highlighted
(if one is active).
Application window:
Shows all applications for the
active probe. The last active
application is marked.
Setting (program) window:
Shows all settings for the active
application. The last active
setting is marked.
Selection of a probe:
Select the corresponding probe field using the trackball.
Each field shows the name and a picture of the corresponding probe.
The selected probe is indicated when it is highlighted.
At the same time the application field appear.
Upon selection, the programmed user settings come into view. With the trackball select the setting.
For starting the system review: Starting the System
(chapter 4.5.1)
4.5.1 Starting the System
Clicking the [OK] button will load the preset.
The probe is initialized, the main menu (2D mode) and the ultrasound image appears on the monitor in
write mode (real time display).
Return to the previously used active mode menu (2D mode, M mode, ......)
without any changes.
Note:
Key [Exit] and key [Probe] provide the same function. You may exit eventually by one of the keys,
if no change of a probe or an application was made.
If a change was made in the Application window, then the keys turn dark (disabled).
In this case an exit is only possible by selecting [OK].
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 4-5
To Next Page
Loading...
