GE Voluson 730Pro - Manual Trace; Measurement of each Item

Calculations and Patient Reports
14.3.4.4.2 Manual Trace
1. After obtaining a feasible Doppler spectrum, press the [Calc] key on the control panel.
The OB Calculations menu appears in the menu area.
2. Select the appropriate item and select [Manual Trace].
3. The cursor appears on the Doppler spectrum. Move the cursor to the start point of the period and
press the right or left trackball key [Set].
Note:
To readjust the traced line press the upper trackball key
[Undo] repeatedly.
4. Trace to the end of the period and press the [Set] key once more.
Remarks:
• Depending on the setting in the Measurement Setup, the envelope curve will be performed with a
continuous trace line or by setting points.
To select the Doppler Manual Trace Method review: General Measurement Setup
(chapter 18.3.1)
14.3.4.4.3 Measurement of Each Item
1. After obtaining an appropriate image, press the [Calc] key.
2. Select the appropriate item (PSV, EDV).
3. The cursor appears on the screen. Perform the measurement using the right or left trackball key.
Voluson
®
730Pro - Basic User Manual
105831 Rev. 0 14-15