Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 5 DHCP Configuration
Huawei Technologies Proprietary
5-9
Operation Command
Delete the client MAC address in the
static binding
undo static-bind mac-address
By default, no static address binding is configured for any global DHCP address pool.
 Note:
The static-bind ip-address command must be used along with the static-bind
mac-address command. If you use the command repeatedly, the new configuration
will overwrite the previous one.
II. Configure static address binding for a VLAN interface address pool
Perform the following configuration in VLAN interface view. Each VLAN interface
address pool supports multiple IP-MAC address bindings.
Table 5-7 Configure static address binding for the VLAN interface address pool
Operation Command
Configure a static address binding in the
current VLAN interface address pool
dhcp server static-bind ip-address
ip-address mac-address mac-address
Delete the static address binding in the
current VLAN interface address pool
undo dhcp server static-bind
{ ip-address ip-address |
mac-address mac-address }
By default, no static address binding is configured for any VLAN interface address pool.
III. Configure dynamic address allocation
To dynamically allocate addresses to clients (including permanent and temporary
leases) using an address pool, you should assign an address range to the pool.
Perform the following configuration in DHCP address pool view.
Table 5-8 Configure an IP address range for dynamic allocation
Operation Command
Configure an IP address range for dynamic
allocation.
network ip-address [ mask netmask ]
Delete the IP address range for dynamic
allocation.
undo network
To Next Page
Loading...
Need help?
General
