Huawei Quidway S3500 Series User Manual

Operation Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 6 DHCP Snooping Configuration
Huawei Technologies Proprietary
6-2
6.2 Configuring DHCP Snooping
6.2.1 DHCP Snooping Configuration Task
The following table describes DHCP snooping configuration tasks:
Table 6-1 DHCP snooping configuration task
Configuration Command Remarks
Enter system view
system-view
––
Enable DHCP
snooping on the
switch
dhcp-snooping
Optional. By default, DHCP
snooping is disabled.
Enter Ethernet port
view
interface { interface-type
interface-number |
interface-name }
––
Set the port as trusted
dhcp-snooping trust
Optional. By default, no port is
set as trusted.
(S3526E/S3526E FM/S3526E
FS/S3526C support)
Display the
association table
recorded by DHCP
snooping
display dhcp-snooping
Optional, any view
Display the enable
status of DHCP
snooping and
information about the
trusted port
display dhcp-snooping
trust
Optional, any view
(S3526E/S3526E FM/S3526E
FS/S3526C support)
Caution:
You must first disable DHCP relay (no DHCP server is configured on any Layer 3 port)
before enabling DHCP snooping on the switch.
6.2.2 DHCP Snooping Configuration Example
I. Networking requirements
z SwitchA (S3500) works as a Layer 2 switch. Enable DHCP snooping on it.
z SwitchA records the IP address for DHCP client to access the Internet, and
confirms the association between the applied IP address and host MAC address.

Huawei Quidway S3500 Series Specifications

General

Brand	Huawei
Model	Quidway S3500 Series
Category	Network Router
Language	English