Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 8 SSH Terminal Services
Huawei Technologies Proprietary
8-3
8.1.2 Configuring SSH Server
Basic configuration tasks refer to those required for successful connection from SSH
client to SSH server, which advanced configuration tasks are those modifying SSH
parameters.
Configuration tasks on SSH server include:
z Setting system protocol and link maximum
z Configuring and deleting local RSA key pair
z Configuring authentication type
z Defining update interval of server key
z Defining SSH authentication timeout value
z Defining SSH authentication retry value
z Entering public key view and editing public key
z Associating public key with SSH user
I. Setting system protocol
You must specify SSH protocol for the system before enabling SSH.
Please perform the following configuration in VTY user interface view.
Table 8-1 Setting system protocols and link maximum
Operation Command
Set system protocol and link maximum protocol inbound { all | ssh | telnet }
By default, the system supports both Telnet and SSH protocols.
Caution:
If SSH protocol is specified, to ensure a successful login, you must configure the AAA
authentication using the authentication-mode scheme command. The protocol
inbound ssh configuration fails if you configure authentication-mode password and
authentication-mode none. When you configure SSH protocol successfully for the
user interface, then you cannot configure authentication-mode password and
authentication-mode none any more.
II. Configuring and canceling local RSA key pair
In executing this command, if you have configured RSA host key pair, the system gives
an alarm after using this command and prompts that the existing one will be replaced.
To Next Page
Loading...
Need help?
General
