Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 6 RMON Configuration
Huawei Technologies Proprietary
6-2
6.2 Configure RMON
RMON configuration includes:
z Add/Delete an Entry to/from the Alarm Table
z Add/Delete an Entry to/from the Event Table
z Add/Delete an Entry to/from the History Control Table
z Add/Delete an Entry to/from the extended RMON alarm table
z Add/Delete an Entry to/from the Statistics Table
6.2.1 Add/Delete an Entry to/from the Alarm Table
RMON alarm management can monitor the specified alarm variables such as the
statistics on a port. When a value of the monitored data exceeds the defined threshold,
an alarm event will be generated. Generally, the event will be recorded in the device log
table and a Trap message will be sent to NMS. The events are defined in the event
management. The alarm management includes browsing, adding and deleting the
alarm entries.
You can use the following commands to add/delete an entry to/from the alarm table.
Perform the following configuration in system view.
Table 6-1 Add/Delete an entry to/from the alarm table
Operation Command
Add an entry to the
alarm table.
rmon alarm entry-number alarm-variable sampling-time
{ delta | absolute } rising-threshold threshold-value1
event-entry1 falling-threshold threshold-value2
event-entry2 [ owner text ]
Delete an entry from
the alarm table.
undo rmon alarm entry-number
6.2.2 Add/Delete an Entry to/from the Event Table
RMON event management defines the event ID and the handling of the event by
keeping logs, sending Trap messages to NMS or performing the both at the same time.
You can use the following commands to add/delete an entry to/from the event table.
Perform the following configuration in system view.
Table 6-2 Add/Delete an entry to/from the event table
Operation Command
Add an entry to the
event table.
rmon event event-entry [ description string ] { log | trap
trap-community | log-trap log-trapcommunity | none }
[ owner rmon-station ]
To Next Page
Loading...
Need help?
General
