Operation Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 2 QoS Configuration
Huawei Technologies Proprietary
2-17
Perform the following configuration in system view.
Table 2-24 Map configuration
Operation Command
Configure “COS
->Local-preced
ence” map
qos cos-local-precedence-map cos0-map-local-prec
cos1-map-local-prec cos2-map-local-prec cos3-map-local-prec
cos4-map-local-prec cos5-map-local-prec cos6-map-local-prec
cos7-map-local-prec
Restore its
default value
undo qos cos-local-precedence-map
By default, the switch uses the default mapping relationship.
II. Configuring the queue scheduler
You can use the following command to configure the queue scheduler.
Perform the following configuration in system view.
Table 2-25 Configuring the queue scheduling algorithm
Operation Command
Configure the queue
scheduling algorithm
queue-scheduler { strict-priority | wrr queue1-weight
queue2-weight queue3-weight queue4-weight |
wrr-max-delay queue1-weight queue2-weight
queue3-weight queue4-weight maxdelay }
Restore the default
queue scheduling
algorithm
undo queue-scheduler
Ethernet Switch support 3 kinds of queue schedulers, i.e., strict-priority, WRR and
Delay bounded WRR.
By default, the switch uses the strict-priority algorithm.
For details about the command, refer to the Command Manual.
2.3.8 Configuring Traffic Mirroring
The function of Traffic mirroring is to copy the traffic matching ACL rule to the
designated observing port to analyze and monitor the packets.
You can use the following command to configure the traffic mirroring.
Perform the following configuration in system view.