Operation Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 1 File System Management
Huawei Technologies Proprietary
1-10
<Quidway> boot boot-loader switch.app
<Quidway> reboot
1.3.8 FTP server configuration example
I. Networking requirement
Switch serves as FTP server and the remote PC as FTP client. The configuration on
FTP server: Configure a FTP user named as switch, with password hello and with read
& write authority over the flash root directory on the PC. The IP address of a VLAN
interface on the switch is 1.1.1.1, and that of the PC is 2.2.2.2. The switch and PC are
reachable.
The switch application switch.app is stored on the PC. Using FTP, the PC can upload
the switch.app from the remote FTP server and download the vrpcfg.txt from the FTP
server for backup purpose.
II. Networking diagram
Switch
PC
Network
SwitchSwitch
PC
Network
Figure 1-3 Networking for FTP configuration
1) Configure the switch
# Log into the switch (locally through the Console port or remotely using Telnet).
<Quidway>
# Start FTP function and set username, password and file directory.
[Quidway] ftp server enable
[Quidway] local-user switch
[Quidway-luser-switch] service-type ftp ftp-directory flash:
[Quidway-luser-switch] password simple hello
2) Run FTP client on the PC and establish FTP connection. Upload the switch.app to
the switch under the Flash directory and download the vrpcfg.txt from the switch.
FTP client is not shipped with the switch, so you need to buy it separately.
To Next Page
Loading...
Need help?
General
